Curves settings

Introduction

This section describes the Curves settings which are available in the Instructions dialog box in the System Control module.

Note:

How to open and use the Instructions dialog box is described in The Instructions dialog box.

The Curves parameters

The table below describes two parameters in the Curves settings:

Parameter	Description
Store	Determines whether or not the curve data is stored in a result file in UNICORN. Caution! Check that Store is set to ON for all signals that are to be stored. If a curve is set to OFF, data from the monitor concerned cannot be displayed in the curves window during a process run and will not be recorded in any way.
Time between samples	Determines the frequency with which curve data is recorded in UNICORN (this does not affect the reading frequency of the monitor itself). The default setting is for the shortest possible time between samples.

2005-06-15